Congratulations and Thank You for purchasing our 432Hz Earth Star Heart Totem. The process for “Planting” your totem is straight forward and easy to do with just a few tools (a shovel and a level).  

Steps: 

Inventory:  You should have 3 items

-    A hand crafted Heart Totem with an attached USB power cord

-    A water resistant USB 110V Power Plug

-    18 inch long PVC pipe with a paint line 2 inches below the top

Installation:  Using a shovel or pole digger, dig a hole 16” deep.  Install the included 18 inch long PVC pipe into the ground.  Leave 2 inches of the unpainted PVC pipe above the ground’s surface. Use a level on top of the pipe before filling in the dirt around it to make sure the pipe is level. Pack the dirt in completely around the pipe so it does not move.  Leave the inside area of the pipe free of all dirt.  This will allow the sound to travel and penetrate the earth around the heart totem.     

Place the heart totem on top of the in-ground PVC pipe.  It should gently slide over the exposed pipe.

        Plug it in and enjoy!

You are invited to do a Heart Totem activation ceremony if you choose (visit our website for ideas).

Note:

The sound level is preset for you but can be adjusted higher or lower.  You will find a volume control inside the heart totem base. To access the volume control, you must remove the 2 black screws at the base of the 3 inch totem section.  You can adjust the volume to your desired level.  When re-attaching the totem, be sure to align the holes back up.  They only align in one direction to make sure you get the painted finish correctly positioned. Enjoy!!